Using the StarLeaf Phone
Using PT Mini 3020Last updated May 9, 2017
StarLeaf Personal Telepresence systems are provided with a touchscreen controller: the StarLeaf Phone 2120. You use the StarLeaf touchscreen controller as the means for making and controlling video calls with Personal Telepresence. Through the touchscreen controller you can access the directory and contacts. You can use the touchscreen controller to create ad hoc conferences, and to add and remove participants.
The StarLeaf Phone 2120
The figure below shows the features on the front of the StarLeaf Phone 2120.
|Audio volume up||Press during a call to increase audio volume or, if you are not in a call, press to increase the loudness of the ringer|
|Audio volume down||Press during a call to decrease audio volume or, if you are not in a call, press to decrease the loudness of the ringer|
|Audio mute||Toggle the microphone of the touchscreen controller (or that of the headset) on and off. The button lights when the microphone is off. When you are in a call and your audio mute is on, nobody can hear what you are saying|
Toggle the camera on and off. The button is an LED that lights when the camera is off. When you are in a video call and the video mute is on, nobody in the call can see you
|Headset||Optionally, press to use a headset that you have connected to the headset connector on the rear of the phone. The button lights when the headset is in use.|
Press to use the speakerphone as follows:
|Home||Press to display the home screen of the touchscreen controller from any screen in the interface. Double-press to access the touchscreen controller’s settings|
|Message waiting indicator||Flashes when the touchscreen controller is ringing and lights to indicate that there is a new message|
|Microphone||Audio-only calls that use the speaker, rather than the handset, uses a microphone located in the bottom right of the touchscreen controller casing. Do not obstruct this location|
Out-of-hours power saving for touchscreen controllers
The backlight on a touchscreen controller dims between the hours of 7pm and 7am in the endpoint’s local timezone. When a touchscreen controller is dimmed, it shows a screen saver displaying the time. Touching the dimmed screen causes the backlight to light again. A touchscreen does not dim for one hour after the last time it was touched.
Power saving is automatically enabled for all touchscreen controllers. There is no configuration.