Safety and Compliance: Personal Telepresence 3050
Installation
Read the installation instructions that accompanied the product before connecting this product to its power source.
Ventilation
Do not block any of the ventilation openings of the monitor. Avoid installing the monitor near a heat source such as a radiator and avoid placing it in direct sunlight.
Power connection
The plug that connects the monitor’s power cord to the power source serves as the main disconnect device for the monitor. The power cord must always be easily accessible.
Servicing
Do not remover the cover of the monitor. There are no user-serviceable parts. If you open the monitor or remove its cover you may expose yourself to dangerous voltages or other hazards, and you will invalidate the warranty.
Technical specifications
Power requirements
Caution: Double pole/neutral fusing
Table 1: SPT Monitor ratings
Rating | Value |
---|---|
Nominal voltage | 115V to 230V 50/60 HZ |
Current rating | 2A maximum |
Supply voltage range | 100 to 240V 50/60 Hz |
Over-current protection
Caution —over-current devices must meet applicable national and local electrical safety codes and be approved for the intended application.
Operating environment
The SPT Monitor must only be used within the following environmental conditions:
Table 2: Operating environment
Environment | Temperature | Humidity |
---|---|---|
Operating environment | 0°C to 35°C | 10% to 95% (non-condensing) |
Non-operating environment | -10°C to 60°C | 10% to 95% (non-condensing) |
Approvals information
EU/EEC
COMPLIANCE MODEL: MAP01A
The Declaration of Conformity is available on request.
Directive 2006/95/EC (Low Voltage Directive):
- Standard EN 60950-1
Directive 2004/108/EC (EMC Directive):
- Standard EN 55022, Class A
- Standard EN 55024
- Standard EN 61000
USA
Approved according to UL 60950-1
Complies with FCC Part 15 Class A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.
Canada
ICES-003 Class A Notice
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.