Installation

View the installation instructions in the installation sheet that accompanies the StarLeaf Personal Telepresence Mini 3020 (PT Mini) and the information on this page, before you connect the PT Mini to its power source.

Ventilation

Do not block any of the ventilation openings of the PT Mini.

Avoid installing the PT Mini near a heat source such as a radiator and avoid placing it in direct sunlight.

Servicing

Do not remove the end plates of the PT Mini. There are no user-serviceable parts. If you open the PT Mini or remove its cover you may expose yourself to dangerous voltages or other hazards, and you will invalidate the warranty.

Power requirements

The plug that connects AC power to the AC/DC adaptor is the main disconnect device for the PT Mini and must always be easily accessible.

The PT Mini must be connected to the AC/DC adaptor (StarLeaf part number 712-00030).

The PT Mini relies on the building’s installation for short-circuit (over current protection).

Ensure that the protective device is not rated greater than: 120 VAC, 15 A U.S, (240 VAC, 10 A international).

Caution: Over-current devices must meet applicable national and local electrical safety codes and be approved for the intended application.

The table below shows the power ratings of the PT Mini when it is powered by the AC/DC adaptor:

Table 1: AC power ratings

Rating Value
Supply voltage range 100 to 240V 50/60 Hz
Current rating 1.0A maximum

Operating environment

The StarLeaf PT Mini must only be used indoors and within the following environmental conditions:

Table 2: Operating environment

Environment Temperature Humidity
Operating environment 0°C to 35°C 10% to 95% (non-condensing)
Non-operating environment -10°C to 60°C 10% to 95% (non-condensing)

Approvals information

EU/EEC

COMPLIANCE MODEL: YUK01A

The Declaration of Conformity is available on request.

Directive 2006/95/EC (Low Voltage Directive)

  • Standard EN 60950-1

Directive 2004/108/EC (EMC Directive)

  • Standard EN 55022, Class B
  • Standard EN 55024
  • Standard EN 61000

USA

Approved according to UL 60950-1

Complies with FCC Part 15 Class B

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

Canada

ICES-003 Class B Notice

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.