Installation

Read the installation instructions in installation sheet and the information on this page before you connect the StarLeaf GTm 5250 to its power source.

Install the StarLeaf GTm 5250 only in accordance with the installation instructions.

Ventilation

Do not block any of the ventilation openings of the GTm 5250.

The GTm 5250 uses side-to-side cooling fans. Allow an adequate space on the sides of the unit to promote a good air flow for cooling of the GTm 5250. Do not block the fan inlet or outlets. Ensure that the fan intake is not placed inline with the outlet from any other fan or convection cooled device.

Rack mounting

Read the rack-mounting instructions carefully before you rack mount the GTm 5250. Ensure that the rack will remain stable.

Servicing

Do not remove the cover of the GTm 5250. There are no user-serviceable parts. If you open the GTm 5250 or remove its cover you may expose yourself to dangerous voltages or other hazards, and you will invalidate the warranty.

Power requirements

Over-current protection

Ensure the power supply to the GTm 5250 is protected by a branch circuit protector rated by a maximum of 20A.

Caution—over-current devices must meet applicable national and local electrical safety codes and be approved for the intended application.

The table below shows the power ratings of the GTm 5250:

Table 1: AC power ratings

Rating Value
Supply voltage range 100 to 240V 50/60 Hz
Current rating 5A maximum

Operating environment

The GTm 5250 must only be used indoors and within the following environmental conditions:

Table 2: Operating environment

Environment Temperature Humidity
Operating environment 0°C to 35°C 10% to 95% (non-condensing)
Non-operating environment -10°C to 60°C 10% to 95% (non-condensing)

Approvals information

EU/EEC

COMPLIANCE MODEL: MEK01A

The Declaration of Conformity is available on request.

Directive 2006/95/EC (Low Voltage Directive):

  • Standard EN 60950-1

Directive 2004/108/EC (EMC Directive):

  • Standard EN 55032 Class A
  • Standard EN 55024
  • Standard EN 61000

USA

Approved according to UL 60950-1

Complies with FCC Part 15 Class A

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

Canada

ICES-003 Class A Notice

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.