Sony SRG-120DH camera settings
Installing CamerasLast updated March 3, 2017
For more information about installing Group Telepresence, refer to the installation guide.
To install the camera:
- Connect the supplied cable to the HDMI (video out) port on the camera. Connect the other end to the Camera In connector on the codec.
- Connect the supplied camera control cable to the VISCA IN(RS-232) port on the camera. Connect the other end to the Camera Control port on the codec.
- Ensure the camera has the correct settings:
Ensure that the System Select controller is correctly set. It must be set to 7. Do not alter this setting.
On the base of the camera, there is a set of tiny switches. Do not alter these from their default settings (all OFF).
- Connect power to the DC 12V power input connector.
The rear view of the camera, shown below, indicates where to connect the cables: